Installation; Positioning The Washing Machine; Adjusting The Feet; Connection To Water Supply - grandimpianti GH6 Instrucciones De Funcionamiento

www.groupdynamics-laundry.com
sales@groupdynamics.lv

Installation

Positioning the washing machine

The washing machine can be installed as a built-in
or freestanding unit. Position the machine so that
the electrical plug is easily accessible.
A. Built-in
The washing machine can be installed under a
counter top with a working height of 850-900 mm.
Leave a 5 mm space around the entire machine,
including between the rear edge of the top cover
and the wall behind it.
B. Freestanding
The washing machine can be positioned beside
or under a tumble dryer.

Adjusting the feet

Keep the noise that the machine produces to a
minimum by adjusting the feet so that the machine
is steady and balanced on the floor. Tighten the
lock nuts.

Connection to water supply

Water connection should be carried out by an
appropriately qualified person. Connect the
machine using the accompanying supply hose.
Water pressure should be 0.1–1MPa (approx.
2
1–10kp/cm ; 10–100N/cm
stopcock on the water pipe.
If the pipes are newly installed, it may be wise to
flush them through so that any dirt is washed
away. Otherwise, dirt can clog the filter in the
machine's water intake and cut off the water
supply.
Locking nut
2
). There should be a
Use only the supply hose supplied with the
machine. Do not re-use old hoses or other loose
supply hoses.
Water intake
At the factory, the machine is set to take in a
mixture of hot and cold water. The machine can
be set for cold water intake only. This setting must
be made by a qualified professional. Contact the
service division.
21