Daitsu DS-18UIAK Manual Del Usuario página 45

Installation of Indoor Unit
3. Wrap the insulating tube with wide rubber belt to prevent
the shift of insulating tube. Slant the drain hose downward
slightly for smooth drainage of condensate.
Note: The insulating tube should be connected reliably with
the sleeve outside the outlet pipe. The drain hose should be
slanted downward slightly, without distortion, bulge or
fluctuation. Do not put the outlet in the water.
Connecting Indoor and Outdoor Electric Wires
1. Open the front panel.
2. Remove the wiring cover as shown in Fig 6.
3. Make the power connection cord pass through the hole at the back of indoor unit.
4. Reinstall the cord anchorage
5. Reinstall the front panel.
Wiring Cover
Fig.6
NOTE:
All wires between indoor and outdoor units must be connected by the qualified electric
contractor.
Electric wires must be connected correctly. Improper connection may cause malfunction.
●
Tighten the terminal screws
●
After tightening the screws, pull the wire slightly to confirm whether
●
Make sure that the electric connections are earthed properly to prevent electric shock.
●
Make sure that all wiring connections are secure and the cover plates are reinstalled
●
properly. Poor installation may cause fire or
All manuals and user guides at all-guides.com
and wiring cover.
18、24K Heat pump type:
N(1) 2 3
yellow-
blue black brown
green
outdoor unit connection
securely.
electric
- 23 -
rubber belt
outlet pipe of
indoor unit
connected
bulge
it's firm or not.
shock.
insulating tube
distortion
Flooded