8.11 Lubrication; 8.12 Maintenance Chart - Textron JACOBSEN PGM Serie Manual Tecnico

8.11 LUBRICATION ____________________________________________________________

The mower was designed for minimum lubrication. Over
greasing will produce high loads on the bearings and
engine; thereby reducing the performance of the
machine.
All maintenance intervals must be performed more
frequently when operating in extremely dusty conditions.
1. Always clean the grease fitting before and after
lubricating.
2. Apply grease with a manual grease gun and fill
slowly until grease begins to seep out. DO NOT use
compressed air guns.
3. For smooth operation of pivot points and other
friction points, apply several drops of SAE 30W oil.

8.12 MAINTENANCE CHART _____________________________________________________

Recommended Inspection and Lubrication Intervals.
Air Cleaner.......................................I ........................................C
Combustion Chamber........................................................................................................... C
Engine Oil ........................................I .................. R ........................................R.......................................... ...................... I
Fuel Line ............................................................................................................................................... R - 2 yrs
Spark Plug .....................................................................................................A/R
Valve Clearance ................................................................................................................... A
Grease Locations (Figure 7C)
1 - Roller .......................................................... L.................................................................................... L.................... II
2 - Height Adj. ........................................................................ L ............................................................................................ II
3 - RT Reel Shaft ............................................. L ...................................................................................... ..................... II
4 - Traction Roller............................................. L ...................................................................................... ..................... II
5 - Clutch Shaft Bearing .......................................................................................................................... L.................... II
6 - Clutch Pivot Shaft .............................................................................................................................. L....................III
7 - Clutch Needle Bearing ........................................................................................................................ ................... III★
8 - Traction Hub ........................... ................... L ...................................................................................... .....................III
9 - Wheel Bearings ............................................................................................................ .................... L.................... II
10 - Reel Clutch Lever ..................................... L ...................................................................................... ..................... II
11 - Chain Case ................................................................................................................. ....................R....................IV
Lubricants
I - SAE 10W-30 Classified API SF or SG.
II - Lithium Grease NLGI - Grade 2.
III - Lubriplate® grease, Jacobsen Part No. 5001581
IV - SAE EP-140 Oil - Drain and Refill
★ - Apply a light coat
All manuals and user guides at all-guides.com
Daily 20
A - Add or Adjust C - Clean
MAINTENANCE
8
9
2 1 3
50 100 300
I - Inspect L- Lubricate
11
4
7 6 1 2
Figure 8D
Yearly Lubricant
R - Replace
8
5
10
27