Tabla de contenido
Publicidad
6
MAINTENANCE & LUBRICATION CHARTS
6.1
GENERAL ________________________________________________________________
!
WARNING
Before you clean, adj ust, or r epair thi s equ ipment,
disengage all drives, lower implements to the ground,
engage p arking br ake, s top engine an d r emove k ey
from ignition switch to prevent injuries
1. Always clean the gr ease fitt ing befo re and a fter
lubricating.
6.2
LUBRICATION CHART______________________________________________________
J
A
J
B
D
C
B
J
A
J
MAINTENANCE & LUBRICATION CHARTS
H
F
E
F
A.
Mower Pivot (3 Fittings)
B.
Front Lift Arms (2 Fittings)
C. Crank Hub
D. Hydraulic Cylinder
E.
Center Lift Arm
2. Lubricate wit h grease that mee ts or exceeds NLG I
Grade 2 LB
sp ecifications. Apply grease wit h a
manual grease gun and fill slowly until grease begins
to seep out. Do not use compressed air guns.
3. Periodically apply a sm all amo unt of li thium based
grease to the seat runners.
4. For sm ooth ope ration of all le vers, pi vot poi nts, an d
other friction points th at ar e no t shown on th e
lubrication ch art apply se veral drops of SA E 30 oil
every 40 hours or as required.
5. Grease fittings (A - F) every 50 hours and fittings (G -
K) every 100 hours.
G
F.
G.
H. Drive Shaft Bearings (2 Fittings)
J.
K.
Control Pedal Pivot (2 Fittings)
Steering Yoke
Reel Bearings (6 Fittings)
Rollers (As Required)
6
29
Publicidad
Tabla de contenido
