Canon Macro Twin Lite MT-26EX-RT Guía De Funcionamiento Básico página 43

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 105
Follow any indications to turn off the product in places where its use is forbidden.
Not doing so may cause other equipment to malfunction due to the effect of
electromagnetic waves and even result in accidents.
To prevent fire, excessive heat, chemical leakage, explosions, and electrical shock,
follow the safeguards below:
• Do not insert the battery's plus and minus ends incorrectly.
Do not fire the flash at anyone driving a car or other vehicle.
It may cause an accident.
Do not use or store the equipment in dusty or humid places.
This is to prevent fire, excessive heat, electrical shock, and burns.
CAUTION:
Do not fire the flash near the eyes.
It may hurt the eyes.
Flash emits high temperatures when fired. Keep fingers, any other part of your body,
and objects away from the flash unit while taking pictures.
This may cause burns or malfunction of the flash.
Do not leave the product in places exposed to extremely high or low temperatures.
The product may become extremely hot/cold and cause burns or injury when touched.
Do not touch any parts inside the product.
This may cause injury.
When the product is not in use for a prolonged period, make sure to remove the
batteries before storing.
This is to prevent malfunction or corrosion.
Be careful when you replace the batteries after continually firing.
The batteries may be hot and it may cause a skin burn.
Cautions for firing continuous flash
To avoid degrading and damaging the flash unit due to overheating, limit
the continuous firing at full output to 20 times or less. After continuously
firing the flash 20 times, allow a rest time of at least 10 min.
If you fire the flash continuously 48 times and then fire the flash again
repeatedly at short intervals, the safety function may activate and
restrict flash firing. With flash firing restriction, the firing interval is
automatically set to approx. 8-20 sec. If this happens, allow a rest
time of at least 25 min.
For details, see "Flash Firing Restrictions due to Temperature
Increase" on page 28.
Denotes the risk of injury.
Safety Instructions
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

0302830502

Tabla de contenido