RIDGID R41121 Manual Del Operador página 5

ADDITIONAL SAFETY RULES
 Never move the workpiece or make adjustment to any
cutting angle while the saw is running and the blade
is rotating. Any slip can result in contact with the blade
causing serious personal injury.
 Avoid awkward operations and hand positions where a
sudden slip could cause your hand to move into the blade.
ALWAYS make sure you have good balance. NEVER
operate your miter saw on the floor or in a crouched
position.
 Never stand or have any part of the body in line with the
path of the saw blade.
 Do not turn the motor switch on and off rapidly. This
could cause the saw blade to loosen and could create
a hazard. Should this ever occur, stand clear and allow
the saw blade to come to a complete stop. Disconnect
your saw from the power supply and securely retighten
the blade bolt.
 If any part of this miter saw is missing or should
break, bend, or fail in any way, or should any electrical
component fail to perform properly, shut off the power
switch, remove the miter saw plug from the power source
and have damaged, missing, or failed parts replaced
before resuming operation.
 Always turn off the saw before disconnecting it to avoid
accidental starting when reconnecting to power supply.
NEVER leave the saw unattended while connected to a
power source.
All manuals and user guides at all-guides.com
 This tool should have the following markings:
 Always carry the tool only by the carrying handle.
 This saw can tip over if the saw head is released suddenly
 Always make sure the saw blade has clearance of
5 - English
• To reduce the risk of injury, user must read and under-
stand the operator's manual before using the miter saw.
• Keep hands and body out of the path of the saw blade.
Contact with the blade will result in serious injury.
• Do not operate saw without guards in place.
• Check guarding system to make sure it is functioning
correctly.
• Do not perform any operation freehand.
• Never reach around the saw blade.
• Turn off tool and wait for saw blade to stop before rais-
ing saw arm, moving workpiece, or changing settings.
• Disconnect the saw from the power source before
changing blade or servicing.
and the saw is not secured to a work surface. Always
secure this saw to a stable work surface before any use
to avoid serious personal injury.
all obstructions before turning the saw on.