Parts And Components; Before Use; Operation - cecotec BAMBA Ionicare 6000 RockStar Soft Manual De Instrucciones

ENGLISH

1. PARTS AND COMPONENTS

Fig. 1
1. Round concentrator
2. Air outlet
3. Wire rack
4. Air inlet
5. Handle
6. Power switch
7. Mode button
8. Levels selector
9. Power cord
10. Plane concentrator
11. Professional concentrator

2. BEFORE USE

Take the product out of the box and remove all packaging material.
Make sure all parts and components are included and in good conditions. If any visible signs of
damage are observed, contact Cecotec's Technical Support Service immediately.

3. OPERATION

Wash and condition your hair.
Dry it with a towel and comb it.
Make sure that the mains voltage matches the voltage stated on the rating label of the
appliance and that the outlet is grounded. Plug the device to a socket.
A slight odour and smoke might appear when heating the device for the first time. This is
perfectly normal and indicates that the system is functioning correctly.
Additional and removable concentrator included.
Note: Make sure the device is turned off when you assemble the concentrator. Do not assemble
or disassemble this component while the device is oprtating to avoid scalds.
Keep your hair 10 cm away from the air inlet while the device is operating to avoid your hair
from getting stuck inside the device.
To avoid burning the hair, keep it more than 3 cm from the air outlet.
Fig. 2
By default, the device will use hot air. Press the mode button to select the alternate temperature
cycle. The indicator light will change from blue to orange.
Press the mode button again to select the cold-air mode.
24
BAMBA IONICARE 6000 ROCKSTAR SOFT