Working Instructions; General Working Instructions; Setting The Cutting Height; Cleaning And Maintenance - Deltafox DG-PLM 4213 4in1 Traducción Del Manual De Instrucciones Original

Wheel drive (only DG-PLM 4213 SP
4IN1 + DG-PLM 4613 SP 4IN1):
3. On: Pull the drive bracket (26) towards
the grip handle (1), the device moves
forward.
Off: Release the drive bracket (26).
The device stops.

Working Instructions

General Working Instructions

• As far as possible, mow the lawn when
it is dry in order to protect the turf.
• Set the cutting height such that the
equipment is not overloaded.
• Run the equipment at walking speed
in lines that are as straight as possible.
For uninterrupted mowing, the lines
should always overlap by a few centi-
metres.
• Do not move backwards.
• On slopes, always work across the
slope.
• If the blade comes into contact with a
foreign body, switch off the engine im-
mediately. Wait until the blade is station-
ary and check the equipment for dam-
age. Restart work only if the equipment
is undamaged.
• Switch off the equipment during longer
breaks and for transportation and wait
until the blade is stationary.
• Clean the equipment after each use, as
described in the "cleaning and mainte-
nance" chapter.

Setting the Cutting Height

The equipment has 6 positions for set-
ting the cutting height (25-35-45-55-65-75
mm):
1. Pull the lever (18) outwards and push
it to the desired position (34).
2. Push the lever (18) back in.
The correct cutting height is around
30 – 45 mm for an ornamental lawn and
around 40 – 65 mm for a utility lawn.
Select a greater cutting height for
the first cut of the season.
Cleaning and
Maintenance
Have any repair and mainte-
nance work not described in
these instructions carried out by
a specialist workshop. Use only
original replacement parts. Risk
of accidents!
Carry out maintenance and
cleaning work strictly with the
engine switched off and spark
plug connectors removed. Risk
of injury!
Allow the equipment to cool
before any maintenance and
cleaning work. Elements of the
engine are hot. Risk of burning!
Wear gloves when handling the
blade.
For cleaning and maintenance
work, also observe the Briggs &
Stratton instruction manual sup-
plied.
GB
99