Installing The Grass Collection Box; Level Gauge; Mulch Kit - Deltafox DG-PLM 4213 4in1 Traducción Del Manual De Instrucciones Original

GB
grip screws (17) on the right
and left of the mounting on the
machine housing (16).
Mounting the upper grip:
4. Screw the upper grip (1) to the
right and left of the lower hand-
lebars (5) using the included
quick-release levers and nuts
(3).
5. Fold out the upper grip (1)
(small picture) and press the
locking lever (3) towards the
handlebar.
6. Fasten the Bowden cable/s (6)
using a cable clamp (4) to the
bottom handle (5).
Installing the Grass
Collection Box
Caution: Do not operate the
equipment with the grass col-
lection box or impact protection
installed incompletely. Risk of
injury!
Assemble grass catchment
basket:
1. Pull plastic loops (29) over bas-
ket rods (30).
2. Place the collection box handle
(22) on the collection box (20).
3. Fasten the collection box handle
(22) using the screws (22.1).
96
Fixing the Grass Collection
Box onto the Equipment:
The mulch kit and lateral grass
ejection must be removed before
using the grass catcher
(see ,
1. Lift up shock protection (21).
2. Hook the grass collection box
(20) into the mounting provided
for this (31) on the rear of the
equipment.
3. Release the impact protection
(21). It holds the grass collec-
tion box in position.
Dismantling/Empty out the
Grass Collection Box:
1. Lift the impact protection (21)
and remove the grass collection
box (20)
2. Empty catchment basket (see
chapter „Disposal / Environmen-
tal Protection") and re-install it.

Level gauge

The level gauge (
the side of the grass catcher (
aerodynamic air guidance provided by the
flap also optimises the filling.
Flap open: grass catcher empty
GO
STOP Flap closed: grass catcher full

Mulch kit

Prior to using the mulch kit, the
lateral ejection canal has to be re-
moved (see
).
24) is located on
20). The
).