Changing The Light - Danby DCR032A1BDB Manual Del Usuario

INSTALLATION INSTRUCTIONS
DOOR REVERSAL
INSTRUCTIONS
(cont)
Tighten the three screws to fi nish installing
the top hinge on top right side of appliance.
Slide the appliance door back on to the top
hinge making sure it's face up. Then replace
the plastic cover on the top bracket by click-
ing it back into position on the door hinge.
Screw the bottom hinge into place on the
new side. Transfer the foot to the other side
and screw to tighten.

CHANGING THE LIGHT

NOTE: Do not throw away any parts when reinstalling the light bulb. Keep them in a safe place until you reinstall a new
bulb. Before removing the light bulb, unplug the appliance from the power supply. Failure to do so could result in electrical
shock or personal injury.
1. Turn off power.
2. Remove the water tray located under the freezer compartment.
3. Hold the lamp cover and push forward towards the inside of the cabinet.
4. Remove the lamp cover.
4. Unscrew the old bulb and install the new bulb.
5. Re-install the lamp cover.
6.Re-install the water tray under the freezer compartment.
Transfer the hinge to the other side of the
fridge.
Check that the door is aligned horizontally
and vertically and that the seals are closed
on all sides before fi nally tightening the up-
per hinge. Re-adjust the leveling feet.
5