KIKKA BOO CHERIE Instrucciones De Uso página 9

THANK YOU FOR CHOOSING OUR PRODUCT. BEFORE USING THIS BABY STROLLER PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY AND KEEP THESE INSTRUCTIONS
FOR FUTURE REFERENCE.
WARNINGS
• Do not let your child play with this product.
• The assembly and adjustment of the product must be operated by adult, please keep the child away from the moving parts.
• Before use,please make sure all the locking devices are in locked.
• To avoid injury ensure that your child is kept away then unfolding and folding this product.
• Always use the restraint system.
• This product is not suitable for running or skating.
• Please do not let the child unattended.
• Please do not leave your child alone with the stroller.
• Parking device shall be engaged when placing and removing the children.
• Please keep the PE bags from child to avoid danger of su ocation.
• Please do not use bicycles, motorcycles, cars and others to tractionforward to damage the stroller.
• Any load attached to the handle and/or on the back of the backrestand/or on the side of the vehicle will a ect the stability of the
vehicle.
• This baby stroller can carry only one child.
• This baby stroller is suitable for 0-36 months to 15KG.
• The maximum load of basket is 2KG,do not overload.
• Any extra accessories aren't allowed without the seller's permission, only use replacement parts supplied and approved by
the manufacture.
• Please make sure to adjust the backrest angle between 150° to 180° when using for the children under 6 months.
CARRYCOT:
• This Production is only suitable for a child who cannot sit up unaided.
• Only use on a rm, horizontal level and dry surface
• Do not let other children play unattended near the carry cot.
• Do not use if any part of the carry cot is broken, torn or missing
• Do not leave exible carrying handles inside the carry cot.
• Do not lift the carry cot when the canopy tube not at 90 degree position.
• The head of the child in the carry cot should never be lower than body of the child.
• This product is suitable only for a child who cannot sit up unaided, roll over and can not push itself up on its hands and knees. Maximum weight of the child: 9kg, 0-6
months, single baby.
• Only use replacement parts supplied by the manufacturer.
• Do not place the carry cot near an open re or other source of strong heat.
• The handles and the bottom of the carry cot should be inspected regularly for signs of damage and wear.
• KEEP AWAY FROM THE FIRE!
• This product complies with EN 1888-1;
I. PARTS
1. Pushbar adjust button; 2. 5-point harness; 3. Leg rest adjust button; 4. Basket; 5. Front wheels; 6. Leg rest adjust button; 7. Bumper bat detach button; 8. Backrest adjust
puller; 9. Folding lock; 10. Rear wheels brake; 11. Rear wheels release button; 12. Rear wheels; 13. Front wheels release button; 14. Swivel lock;
II. ASSEMBLE/ DISASSEMBLE AND REVERSE THE SEAT
As gure 2.1,Put down the seat as the arrow indicates. Please make sure to lock the seat in place when you hear a "click" sound.
Press the unlock button on both sides of the seat at the same time pull up the seat to take o the seat.
Press the button and lift up the seat as arrow direction in gure 2.2, then assemble the seat in opposite direction as gure 2.3, insert the seat in frame, ensureing you hear
a "click" sound to denote it is locked in position.
Disassemble the canopy . Push the plastic part as the arrow direction in gure 2.4. Then unzipper the canopy to remove it.
III. UNFOLD AND INSTALL
Unfold the chassis: As gure 3.1, open the foldig lock, then hold the push bar and upwards until "click"sound and locks into position. Always check that tha chassis is secure.
Open the seat, adjust the bumper bar until "click"sound then the seat is xed.
Assembling the rear wheels: As gure 3.2, connect the front wheel with the connect pieces. To release the front wheels: press front wheels the disconnect button and pull
out the wheel.
Assembling the rear wheels: As gure 3.3, connect the rear wheels as the arrow direction. To remove the rear wheels: pull the release button and take out the rear wheels.
Push bar adjustment: Press the button, sliding in or out in 3 heights positions.
IV. HOW TO USE HARNESS
Safty belt adjustment: As gure 4,Close: Put the plug into socket until it clicks sound. Open: Press the middle button of socket, pull strips out. Adjust strips length:draw out
the top strip and then draw out the end strip, nally lock it.
ENGLISH