Electrolux ERT17004W8 Manual De Instrucciones página 9

• Do not store flammable gas and liquid in the ap-
pliance, because they may explode.
• Appliance's manufacturers storage recommen-
dations should be strictly adhered to.
Care and cleaning
• Before maintenance, switch off the appliance
and disconnect the mains plug from the mains
socket.
• Before using the appliance for the first time,
wash the interior and all internal accessories with
lukewarm water and some neutral soap so as to
remove the typical smell of a brand-new prod-
uct, then dry thoroughly.
• Do not clean the appliance with metal objects.
• Regularly examine the drain in the refrigerator for
defrosted water. If necessary, clean the drain. If
the drain is blocked, water will collect in the bot-
tom of the appliance.
Installation
Important! For electrical connection carefully
follow the instructions given in specific paragraphs.
• Unpack the appliance and check if there are
damages on it. Do not connect the appliance if
it is damaged. Report possible damages imme-
diately to the place you bought it. In that case
retain packing.
• It is advisable to wait at least four hours before
connecting the appliance to allow the oil to flow
back in the compressor.
• Adequate air circulation should be around the
appliance, lacking this leads to overheating. To
Operation
Switching on
Insert the plug into the wall socket.
Turn the Temperature regulator clockwise to a me-
dium setting.
Switching off
To turn off the appliance, turn the Temperature
regulator to the "O" position.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• turn the Temperature regulator toward lower
settings to obtain the minimum coldness.
• turn the Temperature regulator toward higher
settings to obtain the maximum coldness.
A medium setting is generally the most suit-
able.
5) If a water connection is foreseen
achieve sufficient ventilation follow the instruc-
tions relevant to installation.
• Wherever possible the back of the product
should be against a wall to avoid touching or
catching warm parts (compressor, condenser)
to prevent possible burn.
• The appliance must not be located close to ra-
diators or cookers.
• Make sure that the mains plug is accessible after
the installation of the appliance.
• Connect to potable water supply only.
Service
• Any electrical work required to do the servicing
of the appliance should be carried out by a quali-
fied electrician or competent person.
• This product must be serviced by an authorized
Service Centre, and only genuine spare parts
must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer, in either
its refrigerant circuit or insulation materials. The
appliance shall not be discarded together with the
urban refuse and rubbish. The insulation foam con-
tains flammable gases: the appliance shall be dis-
posed according to the applicable regulations to
obtain from your local authorities. Avoid damaging
the cooling unit, especially at the rear near the heat
exchanger. The materials used on this appliance
marked by the symbol
However, the exact setting should be chosen
keeping in mind that the temperature inside the
appliance depends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Important! If the ambient temperature is high or
the appliance is fully loaded, and the appliance is
set to the lowest temperatures, it may run
continuously causing frost to form on the rear wall.
In this case the dial must be set to a higher
temperature to allow automatic defrosting and
therefore reduced energy consumption.
electrolux 9
5)
are recyclable.