MSA 10207312 Instrucciones De Uso página 9

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

If there is no attachment point on the tool, the loop end of a Detachable Loop (for tools 5 lbs and
under) can be securely wrapped around and taped to the tool using Tool Tether Tape
(P/N 1020138).
1. Measure the diameter of the tool shaft. Use the tool weight and shaft diameter in the following
table to determine the appropriate tool tether and length of tape piece needed.
2. Place the handle of the tool on top of the
3. Guide the opposite end of the tether
4. Pull tight and adjust the slide lock to
MSA Tool Tethers with Carabiners
loop on the loop end of the tether (web
end side down).
including the side release buckle
through the loop.
snugly secure the loop around the tool.
US
9

Publicidad

Tabla de contenido
loading

Tabla de contenido