Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Safety Instructions
!
WARNING!
•
DO NOT connect any tool weighing more than 5 Ibs (2.26 kg) to a person. Tools
weighing more than 5 Ibs (2.26 kg) must be connected to a suitable structure.
•
DO NOT exceed the specified product load capacity rating. See product tables for load
ratings.
•
Connect the carabiner on the end of the tether to a suitable attachment point.
•
DO NOT tie knots in a tether.
•
DO NOT hook the tether to itself.
•
DO NOT connect carabiners to each other.
•
Inspect the tether before each use in accordance with the inspection instructions.
•
Always keep tools tethered at heights. Exchange tools over a secure area (e.g., inside
a controlled container, over a platform, etc.) or connect the tool to a secondary anchor
before disconnecting from the original anchor point.
•
DO NOT alter this equipment or intentionally misuse it.
•
DO NOT use fall arrest or rescue equipment in environments with temperatures greater
than 113°F (45°C) or temperatures lower than -31°F (-35°C).
•
DO NOT use tool tether products adjacent to moving machinery, electrical hazards, or
in the presence of excessive heat, open flame or molten metal.
•
DO NOT use tool tether products as part of a personal fall arrest or restraint system.
•
Any tool tether product that has been subjected to fall arrest forces must be
immediately inspected for damage prior to continued use.
•
DO NOT make a modification to a connected tool or product that will result in a
deviation from the manufacturer's recommendation or specification.
•
DO NOT make tool attachments in a manner that would allow the tool tether product to
be unintentionally disconnected.
•
DO NOT use a tool tether product if it will interfere with the safe working condition, or
operation, of any personal fall protection product or system.
•
DO NOT use a tool tether product if it will interfere with the safe working condition, or
operation, of the connected tool or equipment.
•
Ensure the tool tether is kept free from any and all obstructions including, but not
limited to, entanglement with other workers, yourself, and surrounding objects.
•
DO NOT wrap tool tether components around rough or sharp edges.
•
All connected tools and equipment, including connection points, must be compatible
for use with tool tether products, and properly maintained and inspected in accordance
with the manufacturer's instructions.
•
Ensure proper tool drop clearance. Tool drop clearance is defined as:
Tool Tether Maximum Length + Tool Length + 1 ft (0.3 m) Safety Factor.
•
DO NOT modify a tool or primary anchoring location that could result in manufacturer
guideline deviation.
Failure to follow these warnings can result in serious personal injury or death.
MSA Tool Tethers with Carabiners
US
3
Publicidad
Tabla de contenido
