Check List - Nilfisk Gerni N/G-3000A Instrucciones De Manejo

1/2 min.
4. Close the pistol a few times so the
cleaner is also descaled in the
bypass system.
5. Stop the cleaner and let the
descaling acid work for 5 min.
6. Restart the cleaner.
If the pressure is not down to the operating
pressure the process is repeated. After
descaling the system must be operated
with clean water to remove acid residues.
Close the pistol a couple of times so that
the bypass system of the cleaner is
flushed clean. The cleaner is then ready
for use again.
NOTE! Descaling acid is corrosive; wear
facial protection, protective gloves, etc.
Frost protection
The best frost protection is to place your
high pressure cleaner in a frost-free envi-
ronment. If this is not possible the high
pressure cleaner must be frost protected
as follows:
1. Remove the cover and turn on the
machine.
2. Activate the pistol. Keep squeez-
ACTION WHAT/WHO
Instruct New operator
Check High pressure
hose
Check Pressure
gauge
Check Detergent
suction
Clean Water filter
Clean Fine sand
filter
Check Machine for leaks
Adjust Oil burner
Clean Boiler/coil
Perform Descaling
Check Thermostat
All manuals and user guides at all-guides.com
ing the trigger and turn off the
water supply. Let the machine
empty the water tank. Release the
pistol trigger.
3. Add 2 litres of antifreze mix. to the
water tank (2.6), turn on the water
supply and the machine.
4. Activate the pistol. Keep squeez-
ing the trigger and turn off the wa-
ter supply. Let the machine run
with the pressure regulation handle
in the open position until antifreeze
comes out of the nozzles (2.1) and

CHECK LIST

WHEN/HOW OFTEN
Before operator uses
high pressure cleaner
During daily use
During daily use
Daily - by means of
detergent
Weekly/as needed
As needed
Every other month
Twice a year/
as needed
Yearly/as needed
For pressure increase
over 5 bar
Every other month
(2.2).
The antifreeze can be collected and used
again.
Cleaning
Always keep your high pressure cleaner
clean. This increases the life and function
of the individual parts considerably.
Replacements/destruction
All replaced parts such as fuel filter, water
filter, fine sand filter, Turbo Laser filter as
well as contaminated oil and antifreeze
must be handed in to the local approved
authority/institution for deposit/destruction.
When the high pressure cleaner is no
longer to be used, the detergent as well as
pump and stator oil must be drained off
and delivered in accordance with the
above mentioned instructions. The high
pressure cleaner must likewise be handed
in to the local, approved institution for
destruction.
Any replaced parts from service visits may
be given to the service personnel who will
deliver them to the proper authority.
HOW
Let operator read
instruction guide
Leaks ? - call
service engineer
Too high/too low ? -
call service engineer
Lack of suction/leaks ? -
call service engineer
See maintenance
See maintenance
Leaks ? - call
service engineer
Call service engineer
Call service engineer
See maintenance
Temperature too high/low ?
- call service engineer
31