General Safety Directions For Power Tools - Deltafox DG-CCS 1820 T Set Traducción Del Manual De Instrucciones Original

of faults, read the "Troubleshoot-
ing" chapter or contact our service
centre.
General Safety Directions for
Power Tools
WARNING! Read all safety direc-
tions and instructions. Omis-
sions in the compliance with safety
directions and instructions can
cause electrical shock, fire and/or
severe injuries.
Retain all safety directions and instruc-
tions for future use.
The term „power tool" in the warnings
refers to your mains-operated (corded)
power tool or battery-operated (cordless)
power tool.
Work area safety:
• Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
• Do not operate power tools in ex-
plosive atmospheres, such as in the
presence of flammable Iiquids, gases
or dust. Power tools create sparks
which may ignite the dust or fumes.
• Keep children and bystanders away
while operating a power tool. Distrac-
tions can cause you to lose control.
Electrical safety:
• Power tool plugs must match the
outlet. Never modify the plug in any
way. Do not use any adapter plugs
with earthed (grounded) power tools.
Unmodified plugs and matching outlets
will reduce risk of electric shock
• Avoid body contact with earthed or
grounded surfaces, such as pipes, ra-
diators, ranges and refrigerators. There
is an increased risk of electric shock if
your body is earthed or grounded.
• Do not expose power tools to rain
or wet conditions. Water entering a
power tool will increase the risk of elec-
tric shock.
• Do not abuse the cord. Never use the
cord for carrying, pulling or unplug-
ging the power tool. Keep cord away
from heat, oil, sharp edges or mov-
ing parts. Damaged or entangled cords
increase the risk of electric shock.
• When operating a power tool out-
doors, use an extension cord suit-
able for outdoor use. Use of a cord
suitable for outdoor use reduces the risk
of electric shock.
• If operating a power tool in a damp
location is unavoidable, use a resid-
ual current device (RCD) protected
supply. Use of an RCD reduces the risk
of electric shock.
Personal safety:
• Stay alert, watch what you are do-
ing and use common sense when
operating a power tool. Do not use
a power tool while you are tired or
under the influence of drugs, alcohol
or medication. A moment of inattention
while operating power tools may result
in serious personal injury.
• Use personal protective equipment.
Always wear eye protection. Protec-
tive equipment such as dust mask, non-
skid safety shoes, hard hat, or hearing
protection used for appropriate condi-
tions will reduce personal injuries.
• Prevent unintentional starting. En-
sure the switch is in the off-position
before connecting to power source
and/or battery pack, picking up or
carrying the tool. Carrying power tools
with your finger on the switch or ener-
GB
65