Maintenance / Cleaning; Cleaning; Maintenance Intervals; Table Of Maintenance Intervals - Deltafox DG-CCS 1820 T Set Traducción Del Manual De Instrucciones Original

Maintenance / Cleaning

Ask our service centre to carry out
any work that is not described in
these instructions. Use only origi-
nal parts.
Turn off the appliance and, before
doing any servicing, remove the
battery.
Use cut-protection gloves when
handling the chain or the chain bar.
Risk of cuts!

Cleaning

Do not use cleaning agents or sol-
vents. You may otherwise irrepara-
bly damage the appliance.

Table of maintenance intervals

Machine Part
Komplette Maschine
Accessible screws
and nuts
Chain wheel
Saw chain
Blade
Action
Check condition, replace damaged
parts if necessary
Tighten
Check, replace if necessary
Check, oil, sharpen or replace if
necessary
Check, turn, clean, oil
• Keep clean the ventilation slots
( 20), motor housing (
handles of the appliance. Use a damp
cloth or a brush.
• Only dry wipe the saw chain. After
cleaning, lightly oil the saw chain with
chain oil. Apply individual drops of oil
to the joints and the points of the teeth
on the individual chain links.

Maintenance intervals

Carry out the maintenance work listed
in the table below at regular intervals.
Regular maintenance of your equipment
extends the lifespan of the equipment.
You will also achieve optimum cutting per-
formances and avoid accidents.
Before
each use





GB
20) and
After 10 ope-
rating hours

73