DeWalt DWS7085 Manual De Instrucciones página 3

IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT
THIS OR ANY D WALT TOOL, CALL US TOLL FREE AT:
E
1-800-4-D WALT (1-800-433-9258)
E
Safety Instructions for Worklights
WARNING! Read and understand all instructions.
Failure to follow all instructions listed below may
result in electric shock, fire and/or serious personal injury.
WARNING: For your own safety, read the tool
instruction manual before using any accessory. Failure
to heed these warnings may result in personal injury and
serious damage to the tool and the accessory. When
servicing this tool, use only identical replace ment parts.
WARNING: To reduce the risk of eye injury,
ALWAYS use eye protection when operating the
miter saw.
The DWS7085 is for use only with D
attachment miter saws.
SAVE THESE INSTRUCTIONS
• Tool service must be performed only by qualified
repair personnel. Service or maintenance performed by
unqualified personnel may result in injury. To locate your
nearest D WALT service center call 1-800-4-D
E
433-9258) or go to http://www.dewalt.com on the Internet.
• Do not place the worklight in a position which may cause
anyone to intentionally or unintentionally stare into the
worklight. Serious eye injury could result.
• Do not disassemble the worklight or worklight power
supply. There are no user serviceable parts inside.
• Do not modify the worklight in any way. Modifying the
worklight may result in risk of injury.
• The worklight is intended for lighting the workpiece area
and is not a safety device.
• Do not remove or deface warning labels.
• Use Miter Saw Worklight System only with specifically
designated D
Worklight System on non-designated tools may create a risk
of injury.
• Use worklight part # 641437-00 only with worklight power
supply part # 654657-00. Use of worklight with another
power supply may create injury.
• The label on your tool may include the following symbols.
V ...................volts
II ...................Class II worklight
................alternating current
W ..................watts
Installation of Miter Saw LED
Worklight System
WARNING: Read all instructions for the Installation of Worklight
Power Supply and the Installation of Worklight before proceeding
WALT light/laser
E
with the Installation of the Miter Saw Worklight System.
INSTALLATION OF THE WORKLIGHT POWER SUPPLY
(WPS)
WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments
or accessories.
WALT (1-800-
E
WARNING: To reduce the risk of serious personal injury,
DO NOT operate saw without the cover or power supply in
place.
1
WALT Miter Saws. Use of Miter Saw
E
mW .........milliwatts
.......direct current
Hz ...........hertz