Remote Controller Specifications - Hiyasu ASE 18UIAM Manual De Funcionamiento

06Manual 26Hiyasu ENG 2/1/07

REMOTE CONTROLLER SPECIFICATIONS

Remote Controller Specifications
Model
Rated Voltage
Lowest Voltage
of CPU Emitting
Signal
Reaching Distance
Environment
Temperature Range
Introduction of Function Buttons on the Remote Controller
1- On/off Button:
Push this button to start the unit operation. Push the button
again to stop the unit operation.
2- Mode Button:
Each time you press the button, a mode is selected in a
sequence that goes from AUTO COOL DRY, HEAT and FAN
only as the following figure indicates:
15:25 Página 53
R71A/E
3.0V
2.0V
8m (when using
3.0 voltage, it Gets 11m)
-5 o C ~ 60 o C
Performance Features
1- Operating Mode: COOL HEAT DRY FAN only and AUTO .
2- Timer Setting Function in 24 hours.
Indoor Setting Temperature Range : 17 C~30 C.
3-
4- LCD (Liquid Crystal Display) of functions.
AUTO COOL DRY
NOTE: HEAT only for Heat Pump
Button : Push the button to increase the indoor tem-
3-
perature setting to 30C.
Button : Push the button to decrease the indoor tem-
4-
perature setting to 17C.
Fan Button: This button is used for selecting Fan Speed.
5-
Each time you press the button, a fan speed is selected in a
sequence that goes from AUTO LOW MED to HIGH, then
back to Auto. When you select the AUTO or DRY mode, the
fan speed will beautomatically controlled and you can not set
the fan speed.
6- Sleep/Turbo Button: Press this button to select SLEEP or
TURBO mode. Each time you press the button, the opera-
tion mode is shifted in the direction of the arrow. When the
operation mode is either DRY or FAN only, this function can
not be used.
SLEEP SLEEP OFF
Swing Button: Press the SWING button to activate the
7-
swing feature. Push the button again to stop.
Air direction Button: Press this button to change the swing
8-
angle of the louver. The swing angle of the louver is 6oC for each
press. When the louver swing at a certain angle which would affect
the cooling and heating effect of the air conditioner, it would auto-
matically change the swing direction.
No symbol will appear in the display area when press this button.
Timer on Button: Press this button to initiate the auto-on
9-
time sequence. Each press will increase the auto-timed set-
ting in 30 minutes increments. When the setting time dis-
plays 10Hr, each press will increase the auto-timed setting
60 minutes increments. To cancel the auto-timed program,
continue pressing the button
10- Timer off Button: Press this button to initiate the auto-off
time sequence. Each press will increase the auto-timed set-
ting in 30 minutes increments. When the setting time dis-
plays 10Hr, each press will increase the auto-timed setting
60 minutes increments. To cancel the auto-timed program,
continue pressing the button until nothing displays.
HEAT FAN
TURBO TURBO OFF
53