Sony TA-FA1200ES Manual De Instrucciones página 14

3
Press u to display "<2-Auto
Calibration>," then press
ENTER to enter the menu.
4
Press u to display "CAL TYPE,"
then press ENTER to enter the
parameter.
5
Press U/u to select the
parameter, then press ENTER
to enter the selection.
Calibration
type
ENGINEER
FULL FLAT
6
Press U to display "AUTO CAL
START?," then press ENTER to
start the measurement.
Measurement starts in five seconds. A
countdown appears on the display.
While the time is counting down, stand
away from the measurement area to
avoid measurement error.
7
Measurement starts.
The measurement process will take
approximately 10 seconds. Wait until the
measurement process completes.
Tip
When special speakers, such as dipole speakers, are
used, the measurements may not be performed
correctly or auto calibration cannot be performed.
To cancel auto calibration
Auto calibration is cancelled when you change
the volume, change the input source, change
the speaker selection, press MUTING, or
connect headphones.
14
GB
Explanation
Sets the frequency
characteristics to a set that
matches that of the Sony
listening room standard.
Makes the measurement of
frequency from each
speaker flat.
Confirming/saving the
measurement results
1
Confirm the measurement
result.
When the measurement ends, a beep
sounds and the measurement result
appears on the display.
Measurement Display
result
When the COMPLETE Proceed to step
measurement
process
completes
properly
When the ERROR
measurement CODE XX
process fails
2
Press U/u repeatedly to select
the item, then press ENTER.
Item
RETRY
SAVE EXIT
WRN CHECK
EXIT
When error codes appear
Try the remedies and re-perform the auto
calibration.
Error code Cause and remedies
CODE 31 SPEAKERS (OFF/A/B/A+B) is
set to OFF. Select A or B and re-
perform the auto calibration.
When using a bi-wiring
connection, set SPEAKERS
(OFF/A/B/A+B) to A+B.
Explanation
2.
See "When
error codes
appear" (page
14).
Explanation
Re-performs the auto
calibration.
Saves the measurement
results and exits the setting
process.
Displays a warning
concerning the
measurement results. See
"When you select "WRN
CHECK"" (page 15).
Exits the setting process
without saving the
measurement results.