Sony TA-FA1200ES Manual De Instrucciones página 5

Setting the speaker impedance
• Be sure to turn the power off before
adjusting the IMPEDANCE SELECTOR.
• When you connect all speakers with a
nominal impedance of 8 ohms, set the
IMPEDANCE SELECTOR to "8Ω ." When
connecting other types of speakers, set it to
"4Ω ."
• When you connect speakers to both the
SPEAKERS A and B terminals, connect the
speakers with a nominal impedance of 8
ohms or higher.
– When you connect speakers with
impedance of 16 ohms or higher in both
"A" and "B" configuration:
Set IMPEDANCE SELECTOR to "8Ω ."
* If you have an additional speaker system, connect
them to the SPEAKERS B terminals. You can
select the speaker system you want to use with the
SPEAKERS (OFF/A/B/A+B) on the front panel
(page 11).
SPEAKERS B terminals*
Speaker A Speaker A
(R) (L)
– For other types of speakers in other
configurations:
Set IMPEDANCE SELECTOR to "4Ω ."
• If you are not sure of the impedances of the
speakers, refer to the operating instructions
supplied with your speakers. (This
information is often on the back of the
speaker.)
IMPEDANCE SELECTOR
5 GB