Flash Techniques; Bounce Flash; Bounce Flash With A Reflector Card; Bounce Flash With Secondary Reflector - Metz MECABLITZ 58 AF-1 C digital Manual De Instrucciones

10. Flash techniques

10.1 Bounce flash

Bounce flash illuminates the subject more softly and reduces dense shadows. It
also reduces the drop in light from foreground to background that occurs for
physical reasons.
The main reflector of the flash unit can be swivelled horizontally and tilted
vertically for bounce flash. To avoid colour cast in your shots, the reflective surfa-
ce should be colour-neutral or white. For frontal fill-in lighting, the secondary
reflector can also be activated in the Select Menu (see 7.9).
When tilting the main reflector vertically, make sure that it is turned
through an angle that is wide enough to prevent direct light from falling
on the subject. The reflector should be tilted at least as far as the 60° lock-
in position.
Flash ranges do not appear on the display when the main reflector is turned.

10.2 Bounce flash with a reflector card

The use of bounce flash with the integrated reflector card
lights in the eyes of human subjects.
• Tilt the reflector head upwards by 90°.
• Pull the reflector card together with the wide-angle diffuser
from the reflector head
• Hold the reflector card and insert the wide-angle diffuser
tor head.
108

10.3 Bounce flash with secondary reflector

When the main reflector
also be activated in the Select Menu for frontal fill-in lighting of the subject (see
7.9).
Using the secondary reflector
bounce flash with a swivelled or tilted main reflector
not swivelled or tilted, the secondary reflector will not be activated for the shot.
If the light from the secondary reflector is too bright, it can be reduced by half in
the Select Menu (see 7.9).
The secondary reflector is not supported by the stroboscopic, modelling
light (ML) and remote flash modes. The secondary reflector does not flash
when the main reflector is in its normal position or is tilted downwards.

10.4 Close-ups / macro shots

In close-ups and macro shots, parallax error between the flash unit and lens may
result in shadows on the lower edge of the image. To compensate for this, the
main reflector can be tilted downwards by an angle of -7°. To do this, depress
can bring out high-
the reflector release button
If the main reflector is tilted downwards, "TILT" is shown on the display to
indicate this.
above out
Certain minimum lighting distances must be maintained for close-up shots to
avoid overexposure.
into the reflec-
The minimum lighting distance is approximately 10% of the maximum
flash range indicated on the LC display. For close-up shots, make sure
that the flash light is not shaded by the lens.
is swivelled or tilted, the secondary reflector
is generally practical and feasible only for
. If the main reflector is
and tilt the reflector downward.
can