Glatz Suncomfort Push Up Manual De Instrucciones página 20

Use
3 locking positions
Slider
Tilting device
with lock
Upper pole
Lower pole
1
Click
Ribs
Ribbons
Cover
Clamping screw
Base
(optional)
Open sunshade
Remove the protective cover, if present
1. Loosen the ribbons
2. Pull the ribs outwards slightly
3. Slide the slider upwards
4. Slider engages audibly above
!
The slider must engage audibly
above. Select one of three locking
positions for optimum tension.
38 39
Click
2
Adjust the sunshade height
When adjusting the sunshade height,
keep a firm hold on the upper pole,
to prevent it lowering accidentally.
1. Hold upper pole firmly
2. Loosen clamping screw
3. Adjust sunshade height to suit
4. Tighten the clamping screw
3
Tilt the sunshade canopy
When tilting the sunshade, hold the
moving part on the upper pole firmly.
1. Hold moving part firmly
2. Push in the lock on the tilting device
completely
3. Tilt sunshade (possible on both
sides)
4
Close sunshade
1. Sunshade canopy in an upright position
2. Lift / unlock slider
3. Pull the slider downwards
4. Pull out / wrap fabric segments
5. Tie the ribbons
!
The lock of the tilting device must
audibly engage when putting the
sunshade in upright position!