Publicidad
Idiomas disponibles
Idiomas disponibles
The outdoor temperature sensor
Remote transmission of outdoor temperature
to Temperature Station by 868 MHz
Shower proof casing
Wall mounting case (mounting at a sheltered
place. Avoid direct rain and sunshine)
Setting up:
When one sensor is used:
First, insert the batteries into the sensor (see "How to install and
1.
replace batteries in the temperature sensor" below).
2.
Within 30 seconds of powering up the sensor, insert the batteries
to the temperature station (see "How to install and replace
batteries in the temperature station" below). Once the batteries
are in place, all segments of the LCD will light up briefly. Then the
indoor temperature and the time as 0:00 will be displayed. If they
are not shown on LCD after 60 seconds, remove the batteries and
wait for at least 60 seconds before reinserting them. Once the
indoor data is displayed, user may proceed to the next step.
3.
After the batteries are inserted, the temperature station will start
receiving data signal from the sensor.
4.
The outdoor temperature should be displayed on the temperature
station. Also, the signal reception icon will be displayed. If this
does not happen after 1 minute, the batteries will need to be
removed from both units and reset from step 1.
5.
In order to ensure sufficient 868 MHz transmission, the final
position between the temperature station and the sensor should
not be more than 100 meters (see notes on "Positioning" and
"868 MHz Reception").
When more than one sensor is used
1.
User shall remove all the batteries from the temperature station
and sensors and wait 60 seconds if setting has been done with
one sensor before.
2.
Insert the batteries to the first sensor.
3.
Within 30 seconds of powering up the first sensor, insert the
batteries to the temperature station. Once the batteries are in
place, all segments of the LCD will light up briefly. Then the indoor
EN2
Publicidad
