Setting Up Your Desk Phone - Jabra T5330 MULTIUSE Manual Del Usuario

3. Setting up your desk phone

3.1
3.2
3.3
Note: AUX port is used for Remote Handset Lifter (RHL). Please refer to Appendix.
4
All manuals and user guides at all-guides.com
If your telephone has a
headset port, go directly to
3.2b.
3.1 Unplug handset cord from
your telephone and connect to
the port on base unit marked
with .
3.2a Connect enclosed telephone
cord to the now empty handset
port on telephone, and to the
port on base unit marked with
.
3.2b (Headset port use only)
Connect enclosed telephone cord
to the headset port on telephone,
and to the port on base unit
marked with .
3.3 Connect AC power adapter
to port on bottom of base unit,
then connect to AC power outlet.
Visual indicator on base will light
green.
3.4
3.5
2 sec
3.6
3.7
3.8 3.9
3.4 Place headset in charge
cradle and charge a minimum of
30 min. before use. A full charge
takes about 2 hours. Visual
indicator on headset will flash
green while headset is charging,
and light steady green when fully
charged.
3.5 Turn on headset by pressing
answer/end button for 2 sec.
(visual indicator will flash twice
with green light and will beep
three times), or by placing
headset in charge cradle. Turn off
headset by pressing answer/end
button for 2 sec. (visual indicator
will flash twice with green light
and will beep three times).
Clear dial tone
3.6 Take headset out of charge
cradle and put it on.
3.7 Lift handset from telephone,
tap the Answer/End button on
the headset to establish an audio
connection and listen for a dial
tone in headset.
3.8 If dial tone is missing or
unclear, slowly slide the clear dial
tone switch on bottom of base
unit through the 3 settings.
3.9 Set switch to the position
that gives the clearest dial tone.
5