Unpacking; Inserting Batteries Into The Remote; Hookup Overview; Before You Get Started - Sony TA-AV561A Manual De Instrucciones

Getting Started

Unpacking

Check that you received the following items with the
amplifier:
• Remote controller (remote) (1)
• Size AA (R6) batteries (2)

Inserting batteries into the remote

Insert two size AA (R6) batteries in accordance with
the + and – marking on the battery compartment.
When using the remote, point it at the remote sensor g
on the amplifier.
When to replace batteries
Under normal use, the batteries should last for about 6
months. When the remote no longer operates the
amplifier, replace both batteries with new ones.
Notes
• Do not leave the remote in an extremely hot or humid
place.
• Do not use a new battery with an old one.
• Do not expose the remote sensor to direct sunlight or
lighting apparatuses. Doing so may cause a malfunction.
• If you don't use the remote for an extended period of time,
remove the batteries to avoid possible damage from
battery leakage and corrosion.
4 EN

Hookup Overview

The amplifier allows you to connect and control the
following audio/video components. Follow the
hookup procedures on the specified pages for the
components that you want to connect to the amplifier.
To learn the locations and names of each jacks, see
"Rear Panel Descriptions" on page 18.
Audio/Video Component
Speaker
Hookups (5)
System
Hookups (6)
VCR
Front
LD player
speaker
(L)
TV game
CD player
Rear
Tape deck
speaker
(L)
Tuner
Turntable
Audio/Video Component
Hookups (5)

Before you get started

• Turn off the power to all components before making
any connections.
• Do not connect the mains leads until all of the
connections are completed.
• Be sure to make connections firmly to avoid hum
and noise.
• When connecting an audio cable, be sure to match
the colour-coded pins to the appropriate jacks on the
components: White (left, audio) to White; and Red
(right, audio) to Red.
Front
speaker
Super
(R)
woofer
Centre
speaker
Rear
speaker
(R)