KPS -LX30LED Manual De Funcionamiento página 31

KPS-LX30LED • Digital light meter
buzzer beeping twice, and "AUTO" will appear on the middle of LCD display.
This indicates that the auto measurement mode is ON.
• Press and hold the KPS-LX30LED power key (4) for a short time to power
on the light meter. The LCD screen will illuminate (about 5 seconds) with the
will appear on the top left position of the LCD display, indicating that the
manual range switching mode has been activated.
• In this mode, each time press and hold the key for a short time, the meter will
• Press and hold the manual range switching key (9) for a short time; "MANU"
key for one second will result in the inscription "MANU" disappearing from
topleft position of LCD display, replaced by "AUTO" appearing in the middle,
to indicate that the meter has switched the manual range switching mode to
switch to 20.00Lux → 200.0Lux → 2,000Lux → 20,000Lux → 200,000Lux
the auto range switchover.
(or 20.00Fc → 200.0 Fc → 2,000 Fc → 20,000 Fc) in sequence; pressing the
activation of the relative value measurement mode. Press and hold the key
• Press and hold the REL/PEAK key (8) of the KPS-LX30LED for a short time,
left position of the LCD interface will disappear.
"REL" will appear on the top left position of the LCD interface, indicating the
(8) for a short time again, the device will exit the relative value measurement
mode and return to the original measurement mode, and "REL" on the top
Figure 4-1
31