KPS -LX30LED Manual De Funcionamiento página 37

KPS-LX30LED • Digital light meter
sensor visor.
• Before zero calibration, the opto-sensor must be covered with the opto-
time to enter the data hold mode.
5.5 Source selection mode
• In non-zero calibration mode, press and hold "HOLD/ZERO" key for a short
• Zero-calibration can be made in any mode.
• Hold the "MAX/MIN/LS" button for one second and the LS value will flash on back to the previous step.
the LCD display (as shown in figure 5-1-5). The meter is now in source se-
lection mode. Press "REL/PEAK" or "HOLD/ZERO" to change the light sou-
normal mode.
rce (L0-L9), long press to accelerate change. Press "RAN" again to switch
- L0 - Standard lighting: 1.000
• Hold the "MAX/MIN/LS" button to save the light source setting and return to
- L1 - LED daytime light: 0.990
- L2 - LED red light: 0.516
• Light source default values:
- L3 - LED amber (yellow) light: 0.815
- L4 - LED green light: 1.216
- L5 - LED blue light: 1.475
- L6 - LED purple light: 1.148
Notice
Figure 5-1-4A
37
Figure 5-1-4B
Tips