Stitch Pattern Selector; Stitch Length Dial; Stitch Width Dial; Reverse Stitch Control - Sears Kenmore 385.15202 Manual De Instrucciones

Stitch Pattern Selector
(_) Setting mark
(_) Stitch pattern selector
The stitch pattern selector determines the stitch you select..
NOTE:
To avoid needle or fabric damage, make sure the needle
is up and out of the fabric while selecting a stitch,
Stitch patterns are color-coded to recommended setting
zone on the stitch length control,
ZONES:
Red: Straight, zigzag and utility stitches
Green: Geometric decorative stitches
Blue: Built-in buttonhole
[] (Model 15208)
Yr (Model 15202)
[]
f..4
,J
Stitch Length Dial
(_) Setting mark
Turn the stitch length dial until the setting mark reaches the
desired stitch length., The higher the number the longer the
stitch_ "0" means "no feed".
• " _" is the recommended setting for buttonhole
stitching,
° Adjust the stitch length dial in the 0.5-4 range when you
sew the zigzag stitch.
NOTE:
Study the red, green and blue zones on the stitch length
control. These are recommended zones of stitch length
and are color-coded to the stitches°
Stitch Width dial
Turn the stitch width dial until the setting mark reaches the
desired stitch width.
The higher the number, the wider the stitch width..
(D Setting mark
When the stitch width is narrow, the right side of the
pattern will be cut off (model 15208).
Example:Pattern5 Width[5] _ _ _ Width[3]
NOTE:
Raise the needle above the fabric, when you turn the
stitch width dial.
Reverse Stitch Control
Press the stitch control to sew in reverse_
f
\
f
___ ,, 4 3
I
I i
i i
I i
2 t 0
I
J
1 2 3 4 5_
3O