Cleaning The Shuttle Race; Cleaning The Shuttle Area; Replacing Shuttle Assembly - Sears Kenmore 385.15202 Manual De Instrucciones

Tabla de contenido

Publicidad

Cleaning
the Shuttle Race
This area must be kept free of dust, lint and tangled thread_
Clean the shuttle race area every three months,
o Cleaning the shuttle area
(_ Bobbin case
(_) Levers
(_ Shuttle race cover
(_ Shuttle
Shuttle race
(_) Center pin on the shuttle
14 Raise the needle bar to its highest point, then and
remove the bobbin case 1(1(1_.
2. Push the shuttle race levers (_) aside, Lift out the shuttle
race cover(_ and take the shuttle (_)ouL
3, Clean the shuttle race (_ with a lint brush,
4_ Put a drop of oil on the center pin of the shuttle (_ and
the shuttle race (_. Do not over oil.
o Replacing
shuttle
assembly
(_ Levers
(_ Shuttle race cover
(_ Shuttle
6) Shuttle race
(_) Center pin on the shuttle
(_ Shuttle driver
(_ Pointed hook
(_ (Oil here)
1, Turn the handwheet so the shuttle driver (_ forms a
half moon on the left side of the machine.
2.. Hold the shuttle (_ by its center pin(_, and position the
shuttle so it forms a half moon on the right side, The
hook(_wili
be on the bottom.,
3, Put the shuttle race cover (_ back into place over the
shuttle assembly.
4. Snap the levers (_) back into the original position.
J
%
®
(
J
60

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Kenmore 385.15208

Tabla de contenido