Publicidad
Step 8
Carefully turn your unit over onto its front edges. Unfold the
å
BACKS (J and K) and lay them over your unit.
Make equal margins along the top and both side edges of
å
the BACKS (J and K). Push on opposite corners of your unit if
needed to make it "square".
Fasten the BACKS (J and K) to your unit using the NAILS (FF).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the SHELVES (H and I) and UPRIGHTS (C, D, and E).
NOTE: Perforations have been provided for access through
å
the BACK. Carefully cut out the holes needed.
Notched edge
The screw holes along the
bottom edge of the BACK will
be used when attaching the
HUTCH to the CREDENZA.
Page 12
All manuals and user guides at all-guides.com
The top edges of the
BACKS must be even with
the top surface of the TOP.
K
J
404975
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
FF
NAIL
(53 used in this step)
These holes must line up
over the SHELVES (H and I)
and UPRIGHTS (C, D, and E).
www.sauder.com/services
Publicidad
