Sauder Hutch 404975 Instrucciones De Montaje página 16

Step 12
Before fastening the DOOR to your unit, be sure the mounting screw is
å
against the stops as shown in the diagram. If it isn't, loosen the mounting
screw to slide it against the stops. Then tighten the mounting screw.
Fasten the DOOR (L2) to the LEFT END (B). Use the screws in the HINGES.
å
You should start each SCREW a few turns before completely tightening
any of them.
Peel the FELT DISC from the FELT DISC CARD (W). Stick the FELT DISC
å
on the DOOR where it comes in contact with the UPRIGHT (E).
Fasten a BACKPLATE (HH) and PULL (GG) to the DOOR (L2). Use a
å
BLACK 1-1/8" MACHINE SCREW (CC).
NOTE: Be sure the post on back of the BACKPLATE inserts into the small
å
hole in the front surface of the DOOR. The small hole will be below the
large hole on the right DOOR and above the large hole on the left DOOR.
Repeat this step for the other DOOR (L2).
å
See the next step for DOOR adjustments.
å
BLACK 1-1/8" MACHINE SCREW
(2 used for the PULLS and BACKPLATES)
Page 16
All manuals and user guides at all-guides.com
W
GG
HH
W
CC
404975
L2
E
B
Stop
Mounting
screw
Hinge
www.sauder.com/services