Black and Decker BD06WT6 Manual Del Usuario página 11

SET UP & USE
C: Align the holes in the top rail with
those in the top of the unit as shown
in Fig. B
Fig. B
D: Secure the top rail to the unit with
the 3/8 Screws as shown in Fig. C.
Fig. C
WARNING: For safety reasons, all
four (4) screws MUST be
securely fastened.
NOTE: Before installing unit, the top
rail must be assembled on the
unit.
INSTALL THE ACCORDION
PANELS
NOTE: Top rail and Sliding Panels at
each side are offset to provide
the proper pitch to the rear of
(5/16).
This is necessary for proper condensed
water utilization and drainage. If you
are not using the Side Panels for any
reason, this pitch to the rear must be
maintained.
A. Place unit on floor, a bench or a
table. Hold the Accordion Panel in
one hand and gently pull back the
center to free the open end. See
Fig.1
Fig. 1
B. Slide the free end "I" section of
the panel directly into the cabinet
as shown in Fig. 2. Slide the panel
down. Be sure to leave enough
space to slip the top and bottom
of the frame into the rails on the
cabinet.
Fig. 2
C. Once the panel has been installed
on the side of the cabinet, make
sure it sits securely inside the
frame channel by making slight
adjustments. Slide the top and
bottom ends of the frame into the
top and bottom rails of the cabinet.
Fig. 3.
Fig. 3
D. Slide the panel all the way in and
repeat on the other side.
Fig. 4
Top left
Bottom Rail
NOTE: If storm window blocks AC, see
Fig. 11.
ENGLISH
" "section
Top Rail
Bottom Rail
Top Rail
Top right
Page 11