Briggs & Stratton 071210 Manual Del Usuario página 8

Generator Control Panel, GC1031 (Figure 4):
4
(A) Located at the generator (a Briggs &
®
Stratton generator is shown)
(B) Located at the transfer switch
Generator Control Panel, Standard (Figure 5):
5
(A) Located at the generator (a Briggs &
®
Stratton generator is shown)
(B) Located at the transfer switch
NOTICE For this system to operate correctly, the
generator controller must have the correct hardware and
software version as specified in the table that follows.
8
Hardware
Revision or Higher
E4
15. Neutral is bonded to Ground with a green wire or a green
wire with a yellow stripe.
Note: Make sure that this Neutral to Ground bond is installed
as specified by all current NEC, state and local codes,
standards and regulations.
16. Tighten all wire connections and fasteners to the correct
torque. See the label inside the transfer switch enclosure
or the values listed in the remote module installation
instructions for the correct torque values.
The Typical Transfer Switch illustration that follows shows
a completed transfer switch installation. The actual
layout can vary. Make sure that the callouts in the Typical
Transfer Switch illustration agree with the components in
the list that follows:
Callout
A
B
C
D
E
F
G
H
J
K
L
M
N
P
R
S
T
U
V
W
X
17. For the correct torque values refer to the decals located
at the Transfer Switch.
NOTICE The wires between the generator and the transfer
switch must be enclosed in the conduit.
Software Revision
or Higher
E1.00
Component
From Utility Watt-Hour Meter
Transfer Switch Enclosure
Terminal J7
Transfer switch Relay Control
Module (TRCM)
Transfer Switch Neutral
Terminal
Neutral Bus
Ground Bus
Distribution Panel
Utility 240 VAC to Generator
Ten or Eight Pin Terminal Strip
Two Pin Terminal Strip
Generator Circuit Breaker
Generator
Generator Neutral Terminal
Generator Ground Terminal
Transfer Switch Ground
Terminal
Load Connection to Distribution
Panel
Service Disconnect Circuit
Breaker
Utility Connection
Generator Connection
Neutral to Ground bond