Operation; Normal Operation; Set The Automatic Transfer Operation; Enclosure Door - Briggs & Stratton 071210 Manual Del Usuario

Operation

Normal Operation

Utility Fail
The generator senses when the utility voltage is below
70 percent of nominal. The engine start sequence initiates
after a 6-second time delay.
Engine Warm-Up
This is the time delay for engine warm-up before transfer.
Transfer
The transfer from the utility to the generator supply occurs
after the voltage is above set levels. The generator control
board will send a transfer signal (12 VDC) to the TRCM
board. Then, the red LED will turn ON and the transfer switch
switches to generator power. The minimum engine operation
time is 5 minutes after transfer.
Utility Pickup
The voltage pickup level is 80 percent of the nominal voltage.
Re-transfer
Re-transfer from the generator to the utility power is
approximately 10 seconds after the utility voltage supply
is above pickup level and the minimum operation time is
completed.
Engine Cool Down
Standard controller - The engine will operate for 1 minute (60
seconds) after re-transfer.
GC1031 controller - The engine will operate for 5 minutes
(300 seconds) after re-transfer.

Set the Automatic Transfer Operation

To set the automatic transfer operation, complete the steps
that follow:
1. In the transfer switch, set the Service Disconnect Circuit
Breaker to the ON position.
2. Set the Generator Disconnect Circuit Breaker to
the ON position.
3. Install a 15 Amp fuse in the generator.
4. Set the generator controller to AUTO.

Enclosure Door

WARNING
Generator and utility voltage could cause electrical
shock or burn resulting in death or serious injury.
• DO NOT allow unqualified persons to operate or
service this equipment.
Open the Door
1. Open the transfer switch door.
12
2. Remove the two exterior thumb screws (A, Figure 8).
3. Carefully lift off the door.
Close the Door
1. Push the door against the enclosure.
2. Put the tab on the enclosure into the slot on the door.
Note: The door can now rest on the tab (B, Figure, 8 ) at the
bottom of the enclosure.
3. Install the thumb screws (A). Tighten them with your
hand.
NOTICE The enclosure door MUST be closed and
secured at all times except when the system is being
serviced.
8

When Calling for Assistance

You must have the Model Number and Serial Number from
each transfer switch or remote module ID label at hand if
it is necessary to contact a local service center regarding
service or repair. Obtain this information from the unit ID
labels located on or inside device. For convenience, record
the information in the For Future Reference section at the
front of this manual.
To contact Briggs & Stratton call 800-732-2989, between 8:00
AM and 5:00 PM CT.

Pre-Service Inspection

Before you service the system, examine all of the installation
carefully.