Bosch CCS180 Manual Del Usuario página 10

BM 2610034442 03-14_CCS180 3/27/14 12:25 PM Page 10
Disconnect battery pack from tool. Loosen the
depth adjustment lever located on the right
side of the tool. Hold the foot down with one
hand and raise or lower saw by the handle.
C LIBR TED DEPTH
BR CKET
SAFETy SWITCH
The safety switch is designed to prevent
accidental starts. To operate safety switch,
press the release button with your thumb on
either side of handle to disengage the lock,
then pull the trigger (Fig. 5). When the trigger
is released the button will engage the safety
switch automatically, and the trigger will no
longer operate. (See Switch & General Cuts
on page 12.)
FIG. 5
S FETY SWITCH
RELE SE BUTTON
All manuals and user guides at all-guides.com
Operating Instructions
DEPTH ADjUSTMENT
Tighten lever at the depth setting desired.
Check desired depth (Fig. 3).
Not more than one tooth length of the blade
should extend below the material to be cut, for
minimum splintering (Fig. 4).
FIG. 3
DEPTH
DJUSTMENT
LEVER
Disconnect battery pack from tool. Set foot to
maximum depth of cut setting. Loosen bevel
adjustment lever, set to 0° on quadrant,
retighten lever and check for 90° angle
between the blade and bottom plane of foot
with a square (Fig. 6). Make adjustments by
turning the small alignment screw from bottom
side of foot, if necessary (Fig. 7).
FIG. 6
TRIGGER
-10-
ONE TOOTH LENGTH SHOULD
PENETR TE WOOD FOR
MINIMUM SPLINTERING
90° CUTTING ANGLE CHECK
BEVEL
DJUSTMENT
KNOB
FOOT
BL DE
FIG. 4
FIG. 7
LIGNMENT
SCREW