Assembling The Guide Bar And Saw Chain - Snapper ESXDCS82 Manual Del Usuario

EN
AR BG CS DA DE ES ET FI FR HR HU IT LT LV NL NO PL PT RO RU SK SL SR SV TR UK
21. Chain drive links
22. Cutter
23. Felling direction
24. Danger zone
25. Escape route
26. Direction of fall
27. Notch
28. Felling back cut
29. Hinge
30. Limb cut
31. Keep work off ground leave support limbs
until log is cut
32. Log supported along the entire length
33. Cut from top (over buck) avoid cutting
earth
34. Log supported one end
35. Under buck
36. Over buck
37. Log supported both ends
38. Bucking a log
39. Stand on uphill side when cutting because
log may roll
40. On/off switch
ASSEMBLY
This chain saw requires no assembly, but user
should know how to assemble the guide bar
and saw chain. Check the chain tensioning
and add oil as described later in this manual
before each operation.
ASSEMBLiNG THE GUiDE BAR AND SAw
CHAiN
See figure 2 - 7
Make sure remove the battery pack from the
unit. Wear protective gloves.
Unscrew the sprocket cover tighten knob
„
(item 15) and remove the sprocket cover.
English (original instructions)
The saw chain should face in the direction
„
of chain rotation. If they face backwards,
turn the loop over.
Place the chain drive links into the bar
„
groove.
Position the chain so there is a loop at the
„
back of the bar.
Hold the chain in position on the bar and
„
place the loop around the sprocket and
make sure it is correctly mounted. Make
sure the bar hole fits well with bolt (item
16) for saw chain tension.
Replace the sprocket cover, turn the
„
chain tension adjust knob (item 13)
clockwise until the saw chain is properly
tensioned. The guide bar must then be
pushed upwards, check chain tension
again, do not tension the chain too tight.
After the chain is well-tensioned, tighten
„
the knob (item 15) again.
NOTE: The saw chain is properly tensioned if,
in the middle of the guide bar, it can be lifted
3mm to 4mm from the edge of the guide bar.
Start the saw again with a new saw chain,
allowing it to run-in for 2~3 minutes.
After the run-in time, check the chain tension
and retighten the chain if necessary.
OPERATiON
For complete charging instructions, refer
to the Operator's Manuals for your Briggs
& Stratton battery pack and charger
models.
NOTE: To avoid serious personal injury,
always remove the battery pack and keep
hands clear of the lock-out button when
carrying or transporting the tool.
BEFORE EACH USE CHECK THE CHAiN
TENSiON
7
wARNiNG