Foot Pedal Adjustment; Storage - Snapper S50xt Serie Manual Del Operador

32
Note: Make sure that the pin is inserted into the holes in both
upper and lower plates of the pin box (B).
To set the cutting height at 1-1/2" (3,37 cm):
1. While sitting in the operator's seat, press the deck lift foot
pedal (C) forward until it locks into the 4-1/2" (11,47 cm)
position.
2. Remove the cutting height adjustment pin from the hole
that it is installed in.
3. Press the deck lift foot pedal forward and then pull the
lock lever (D) towards the rear of the unit to release the
lock.
4. Slowly release the deck lift foot pedal until it comes to
rest against the stationary pin (E) in the 1-1/2" (3,37 cm)
cutting height hole.
5. Place the cutting height adjustment pin in any open
cutting height hole.
To set the cutting height in the range of 1-3/4" (4,40 cm)
and 4-1/4" (10,80 cm):
1. While sitting in the operator's seat, press the deck lift foot
pedal (C) forward until it locks into the 4-1/2" (11,47 cm)
position.
2. Place the cutting height adjustment pin in the desired
cutting height.
3. Press the deck lift pedal forward and then pull the lock
lever (D) towards the rear of the unit to release the lock.
4. Slowly release the deck lift foot pedal until it comes to rest
against the cutting height adjustment pin.
To set the cutting height at 4-1/2" (11,47 cm):
1. While sitting in the operator's seat, press the deck lift foot
pedal (C) forward until it locks into the 4-1/2" (11,47 cm)
position.
24
2. Place the cutting height adjustment pin in any open
cutting height hole. The lift lock lever holds the mower
deck at 4-1/2" (11,47 cm) while cutting.

Foot Pedal Adjustment

The deck lift foot pedal can be adjusted to accommodate the
operator's height for optimal comfort.
To adjust pedal position:
1. Remove the foot pedal (A, Figure 33) from the pedal
mount tab (B).
33
2. Remove the pedal mount hardware (C) and rotate the tab
180 degrees.
3. Reinstall the pedal mount hardware and tighten securely.
4. Reinstall the foot pedal on the pedal mount tab in the
proper orientation as shown in Figure 33.

Storage

Temporary Storage (30 Days or Less)
Remember, the fuel tank will still contain some gasoline, so
never store the unit indoors or in any other area where fuel
vapor could travel to any ignition source. Fuel vapor is also
toxic if inhaled, so never store the unit in any structure used
for human or animal habitation.
WARNING
Never store the unit, with gasoline in engine or fuel tank,
in a heated shelter or in enclosed, poorly ventilated
enclosures. Gasoline fumes may reach an open flame,
spark or pilot light (such as a furnace, water heater, clothes
dryer, etc.) and cause an explosion.
Handle gasoline carefully. It is highly flammable and
careless use could result in serious fire damage to your
person or property.
Drain fuel into an approved container outdoors away from
open flame or sparks.
snapperpro.com