Schumacher Electric PI-1000 Manual Del Propietário página 13

NOTE: If more than one device is to be powered,
start one device at a time to avoid a power surge and
overloading the inverter. The surge load of each device
should not exceed the inverters Continuous Operation
wattage rate.
IMPORTANT: If you are using the power inverter to
operate a battery charger, monitor the temperature of
the battery charger for about 10 minutes. If the battery
charger becomes abnormally warm, disconnect it from
the inverter immediately.
NOTE: You can use an extension cord from the inverter
to the device without significantly decreasing the power
being generated by the inverter. For best operating
results, the extension cord should be no longer than 50
feet.
Using the Inverter to Operate a TV or Audio Device:
The inverter is shielded and filtered to minimize signal
interference. Despite this, some interference may occur
with your television picture, especially with weak signals.
Below are some suggestions to try and improve recep-
tion.
1. Make sure the television antenna produces a clear
signal under normal operating conditions (i.e. at home
plugged into a standard 120-volt AC wall outlet). Also,
ensure that the antenna cable is adequately shielded
and of good quality.
2. Try altering the position of the inverter, antenna
cables, and television power cord. Add an exten-
sion cord from the inverter to the TV so as to isolate
its power cord and antenna cables from the 12-volt
power source.
All manuals and user guides at all-guides.com
• 13 •