cecotec CONGA ROCKSTAR 800 ULTIMATE Manual De Instrucciones página 34

ENGLISH
Switch off the device before start cleaning it.
If cleaning the device with a cloth damped with water or any neutral detergent, the cloth
must be wrung firstly.
Do not let water get inside the device.
After cleaning it, do not leave the device in a sunny or moist place.
Cleaning and maintenance of the filter
Press the dust tank releasing button (Fig. 8) and disassemble the dust tank (fig. 9). Rinse it
with warm water.
Fig. 10
Filters cannot be washed inside a washing machine nor dried with a hair dryer.
Do not brush the filters.
How to clean floor brush
Make sure the device is switched off.
Disassemble the brush following the instructions on this manual.
Remove its transparent cover clean it.
Fig. 11
Cleaning floor brush's housing
Place it on a straight position.
Clean the dirt inside it.
Fig. 12
Cleaning Jalisco brush
Hair is easily removable from the rolling brush just by using a knife to remove it.
Fig. 13
In order to avoid any damages in the brush, the hair can be cut and removed if it is wrapped
around both sides of the Jalisco brush.
Assemble the Jalisco brush into the floor brush.
Fig. 14
Make sure it is properly installed, otherwise the brush will not start operating.
How to charge
The display will automatically show when the device is charging.
When fully charged, the device will stop charging to protect the battery so it will not damage
the battery.
The device can be connected to a power adapter and be charged directly.
Fig. 15
The battery can be removed and a be charged directly.
Fig. 16
It can also be charged in a wall bracket.
Fig. 17
34 CONGA ROCKSTAR 800 ULTIMATE
05564_Conga Rockstar 800 Ultimate_IM_LI_PE_YV_03210301.indd 34 05564_Conga Rockstar 800 Ultimate_IM_LI_PE_YV_03210301.indd 34 31/3/21 9:16 31/3/21 9:16