cam GARA Manual Del Usuario página 16

INSTRUCTIONS FOR USE
comply with standards. we therefore suggest you to replace it. • This car seat is
not designed for sleeping. • The use of this car seat for premature infants could
cause respiration problems for the infant seated in the car seat. It is advisable to
seek medical advice before leaving the hospital. • Never remove the child from the
seat while the vehicle is in motion. • Even if regulation ECE R44 does not forbid
the use of group 1 car seats on the front seats of the car fitted with airbag, we
suggest to install the car seat only on rear seats.
INSTRUCTIONS FOR USE:
1. USING THE CAR SEAT AS GROUP 0+,
from birth till 13 kgs of weight:
- The car seat must be placed ONLy with
your child facing the vehicle seat (opposite
to the driving direction).
- No airbag!
- It must be used ONLy in the lower
position (image 13).
2. USING THE CAR SEAT AS GROUP 1,
FROM 9 TO 18 KGS OF WEIGHT.
- The car seat must be placed ONLy with
your child facing the road (normal
direction of travel).
- NEVER use the car seat in the group 0+
position (image 13).
PLEASE NOTE THAT: the arrows show
where the vehicle harnesses must pass
through in order to fit the car seat in the
correct way.
3. FITTING YOUR CAR SEAT:
3a. Fit your car seat ONLy on vehicle seats
provided with 3 point harness.
3b. The figure shows which seats can be
used to fit the car seat. If you use the
product as a group 0+ car seat, you must
disable the airbag. If this is not possible, the
car seat must be fitted on the rear seats!
USING THE 5 POINT HARNESS:
4. before using the product adjust the
harness on the basis of the height of your
child: the harness must be at the same height
of your child's shoulders or slightly above.
5. Push the lever under the car seat (1) and
recline completely the seat at the same
time (2).
15
6. Press the central adjuster (1) and
slacken the harness at the same time (2).
7. Remove from the metal buckle on
the car seat backrest the 2 harnesses.
8. Remove the harnesses from the
slots and put them in the slots
corresponding to your child's height.
WARNING! Pay attention to the right
fitting of the chests pads.
9. Secure the harness loop to the
metal plate.
10. Open the buckle, let your child sit
down and fasten the buckle again as
shown in the figure.
11. Adjust the 5 point harness by pulling
towards yourself the central adjusting
harness. harnesses must be well tight and
not twisted.
GROUP 0+ CAR SEAT: from birth till
13 kgs of weight.
12. Completely recline the seat unit as
shown in diagram 5.
13. by pushing the button on the rear
part of the car seat backrest, the car
seat reaches the LOwER RECLINED
POSITION (for group 0+ only). To raise
it again, push the button and lift the
backrest at the same time.
14. Put the car seat on the seat as
shown in the figure. The car seat base
must lean in a stable way on the seat
of the car (no airbag).
15. Fasten the adult 3 point belt and
make sure it is passing through the
space as shown in the figure.
16. make the lap belt "A" pass through the