Problems During Software Installation; The Printer Is Not Displayed (Detected) - Canon PIXMA PRO-1 Serie Solucion De Problemas De Configuracion De Red

Problems during Software Installation

The Printer is Not Displayed (Detected)

Check
B
A
Check 1
Make sure that you follow "Connection Checklist" on page 7, then click Redetect (A).
Check 2
Turn off the network device (router, etc.), turn it back on, then click Redetect (A).
Check 3
Make sure that the DHCP function of the network device (router, etc.) is active.
To specify the IP address, set up a wired connection using a USB cable. Click Set Up New
•
Printer (B), then go to in "Specifying the Printer's IP Address" on page 5.
• For details on how to check settings of the network device, refer to the manual supplied with the
network device or contact its manufacturer.
Activate the DHCP function of the network device, then click Redetect (A).
• For details on how to change settings of the network device, refer to the manual supplied with the
network device or contact its manufacturer.

Check 4
Is the printer connected to a network?
• To check if the printer is connected to a
network, print the Network Configuration
B
Page, then make sure that Link Status is set
to Active. To print the Network Configuration
Page, hold down the RESUME/CANCEL
button (C) on the printer until the POWER
lamp (D) flashes 6 times, then release the
RESUME/CANCEL button after the sixth
flash.
A
If the printer is not connected to a network, perform setup again by following the
procedures from "Set Up a Wired Connection" in the printed manual: Getting Started.
Check 5
If the printer is not detected, set up a wired connection using a USB cable. Click Set Up
New Printer (B), then perform the following procedure.
1
Click Next (E) on the Set Up New Printer screen.
2
When the Connect Cable screen appears, connect the printer to the computer with
a USB cable.
For Macintosh, click Next.
When the Set Printer IP Address screen appears, check the IP address settings by referring
•
to Check 4 and onward in "Set Printer IP Address Screen is Displayed" on page 4.
E
C
D
E