Restoring The Printer's Default Lan Settings To Perform Setup Again - Canon PIXMA PRO-1 Serie Solucion De Problemas De Configuracion De Red

4
Select Use next IP address (B) in the
Set Printer IP Address screen.
Select Use following IP address for
TCP/IP Setting (B) in the Set Printer IP
Address screen.
5
Enter the value you want to specify for each of IP Address, Subnet Mask, and
Default Gateway or Router (C), then click Connect (D).
Follow the on-screen instructions to proceed with settings.
If the printer is not connected to a network, perform setup again by following the
procedures from "Set Up a Wired Connection" in the printed manual: Getting Started.
Glossary
• IP address
A numerical identification assigned to each computer or network device connected to a network.
• Subnet mask
A number used to distinguish the network and host portions of an IP address.
• Default gateway
A device required to connect to external networks.
• The printer cannot be used on external networks such as the Internet.

B
C
D
B
C
D

Restoring the Printer's Default LAN Settings to Perform Setup Again

Action
Use the RESUME/CANCEL button on the printer to restore the default state.
1
Disconnect the Ethernet cable.
2
Hold down the RESUME/CANCEL
button (A) on the printer until the
POWER lamp (B) flashes 10 times,
then release the RESUME/
CANCEL button after the tenth
flash.
The LAN setting of the printer is now restored to the default state.
• Perform setup again by following the procedures from "Set Up a Wired Connection" in the printed
manual: Getting Started.
A
B