Bang & Olufsen BeoVision 5 - 42 US Manual página 73

6.12 Plasma Display Panel pixel test, English
Plasma Display Panel (PDP) pixel test
The PDP pixel test checks the status of the PDP, with regard to the number of defective pixels
The test is used:
- before transporting the product or the PDP to a workshop
- before and after service on the PDP
- Please refer to illustrations for:
- Placement of black self-adhesive tape on the PDP
- Placement of buttons on NN Remote control
- Remove front frame and front cloth.
See illustrations, page 6.33.
- Remove the black self-adhesive tape on the PDP. See ➢4.
- Switch on the product.
- Enter service mode, CAT Panel menu.
Press and hold button B and at the same time press button C 3 times within 1 second.
See ➢4 and ➢5.
- Select Aging.
Place the cursor on IIC Mode and press "OK".
Select "Aging", use the up/down arrow buttons to step through the pictures on
the on-screen-display.
Press "OK" to activate the internal test pictures.
Press "OK" to switch between the different test pictures.
- PDP Pixel test.
Use the "GREEN", "RED" and "BLUE" test picture for checking the pixels.
- Exit Service mode.
Press R twice to return to CAT Panel menu.
Press C to exit the service mode.
➢4
LED B
➢5
+
VOL
_
+
R
C OK R