Bang & Olufsen BeoVision 5 - 42 US Manual página 74

Replacement of modules
Actions before dismantling the PDP
NOTE
Replacement of modules
Replacement of contrast screen
Replacement of modules
Replacement of contrast screen
Before dismantling the PDP - disconnect the mains supply and wait minimum
1 minute for the electolytic capasitors to discharge.
Connect ESD-mat.
After replacing module(s) in the PDP follow the test and adjustment procedure as
described in "Test and adjustment after replacement of module(s)" on page 6.16.
Internal cables in the PDP.
Please show precaution when disconnecting cables from sockets.
Follow the instructions described on page:
6.33 - 6.35 PDP in service position
6.38 - 6.49 for selected PCB
Use white gloves to avoid smudging the contrast screen.
Use only the micro fi bre cloth, part no. 3375706 to clean the PDP.
Do not use any kind of cleaning detergents on the PDP.
Follow the instructions described on page:
6.33 - 6.35 PDP in service position
6.37 Remove contrast screen and plasma frame
Replacement of modules, English 6.13