Laser Parallel Adjustment; Laser Vertical Angle Adjustment; Laser Offset Adjustment - Delta Shopmaster S26-272L Manual De Instrucciones

LASER PARALLEL ADJUSTMENT

If you notice the laser line is not perfectly parallel with the
saw blade refer to Figure 27 and follow these instructions:
using a Phillips head screwdriver turn screw (A) until the
laser line is parallel with the saw blade.
LASER VERTICAL ANGLE
ADJUSTMENT
If you notice the laser line does not remain parallel to the
blade as the saw head is lowered to make a cut refer to
Figure 28 and follow these instructions: using a Phillips head
screwdriver turn the screw (B) to adjust the vertical angle of
the laser.

LASER OFFSET ADJUSTMENT

If you notice the laser line is offset from the actual cut line
refer to Figure 29 and follow these instructions: using a
Phillips head screwdriver turn the screw (C) to adjust the
offset.
ADJUSTMENTS
20
FIGURE 27
B
FIGURE 28
C
FIGURE 29
A