Fm Function, Access To Rds Service; Tone Function; Selecting Nicam Sound - Promax PROLINK-3 Premium Manual De Instrucciones

4.11.1 FM function, access to RDS service

The FM function, allows to access to the information associated with the Radio Data
System (RDS), in case of emitting in the frequency of selected demodulation. This
technique offers data in the receiver screen relative to the identification of tuned transmitters
network (Service of Program - PS), as well as after few seconds, short messages (Radio
TEXT - RT), the program type (PTY), the traffic announcements (TA), the program
identification (PI) and traffic program identification (TP) that emits each service.
The PROLINK-3/3C
tuned FM frequency as well as the balance of the number of received erroneous blocks
(EBB) (See figure 44).

4.11.2 Tone function

When the LV function is selected, the speaker of the PROLINK-3/3C
permits a tone whose frequency depends on the level of the signal received. This is
very useful when installing antennas, since the user can locate the peak signal without
having to look continually at the monitor of the level meter.

4.11.3 Selecting NICAM sound

When the NICAM option is selected, it is possible to measure the Bit Error Rate of
the modulation. To obtain this measurement, from the TV operating mode, level
measurement, press key
measurement information displayed on the screen (name assigned to memory, power
supply to external
frequency/channel). In the position relative to the type of Sound will appear the
information about the type of NICAM according to:
Page 86
Premium also shows the level of the received signal and
Figure 44.- RDS service information.
[2] in order to activate the mode of maximum
units, sound, colour
Sound: Type + Error
USER'S MANUAL. PROLINK-3/3C
system, TV standard,
Premium
Premium
level and
06/2005