Specifications; Cleaning And Maintenance; Replacing The Batteries (Fig. E); Defects And Malfunctions - Tunturi Cardio Fit bike B35 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 48
English
Distance
-
Automatically accumulates the distance from
exercise when exercising.
Calorie
-
Automatically accumulates calories burnt when
exercising.
NOTE
This data is a rough guide for comparison of
different exercise sessions which cannot be used
in medical treatment.
Odometer
-
Automatically accumulates the Total distance for all
exercise sessions.
Pulse
-
Display current heart rate if measured.
Before measuring your pulse rate, please place your
palms of your hands on both of your contact pads and
the monitor will show your current heart beat rate in
beats per minute(BPM) on the LCD after 6~7 seconds.
WARNING
During the process of pulse measurement,
because of the contact jamming, the
measurement value may be higher than
the virtual pulse rate during the first 2~3
seconds, then will return to normal level. The
measurement value cannot be regarded as the
basis of medical treatment.
NOTE
:
If the display is faint or shows no figures, please
replace the batteries.
The monitor will automatically shut in standby
mode if there is no signal received after 4
minutes.
The monitor will be auto-powered on when
starting to exercise or at the push of a button.
The monitor will automatically start calculating
when you start to exercise and will stop
calculating when you stop exercising for 4
seconds.

Specifications:

Function
-
Auto scan
-
Time
-
Current speed
displayed is
-
Trip Distance
-
Calories
-
ODO
-
Pulse rate
Battery type
Operating Temperature 0°C ~ +40°C
Storage Temperature

Cleaning and maintenance

The equipment does not require special maintenance.
The equipment does not require recalibration when
it is assembled, used and serviced according to the
instructions.
WARNING
Do not use solvents to clean the equipment.
-
Clean the equipment with a soft, absorbent cloth
after each use.
-
Regularly check that all screws and nuts
are tight.
-
If necessary, lubricate the joints.

Replacing the batteries (Fig. E)

The console is equipped with 2 AA batteries at the rear
of the console.
-
Remove the cover.
-
Remove the old batteries.
-
Insert the new batteries. Make sure that batteries
match the (+) and (-) polarity markings.
-
Mount the cover.

Defects and malfunctions

Despite continuous quality control, defects and
malfunctions caused by individual parts can occur in the
equipment. In most cases, it will be sufficient to replace
the defective part.
-
If the equipment does not function properly,
immediately contact the dealer.
-
Provide the model number and the serial number of
the equipment to the dealer. State the nature of the
problem, conditions of use and purchase date.
1 6
Every 4 seconds
0:00 ~ 99:59
The maximum speed to be
99,9 KM/H
0.00 ~ 99.99 KM
0.0 ~ 999.9 K.Cal
0.1 ~ 999.9 KM
40 ~ 240 BPM
2pcs AA type
-10°C ~ +60°C

Publicidad

Tabla de contenido
loading

Tabla de contenido