Switching The Flash Unit On And Off; The Selection Menu - Metz mecablitz 52 AF-1 Olympus digital Manual De Instrucciones

Ocultar thumbs Ver también para mecablitz 52 AF-1 Olympus digital:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 212

3.3 Switching the flash unit on and off

• Switch on the flash unit with the
52AF-1
The
OLY
mode. To switch off the flash unit, press
the
+
If the flash unit will not be used for an
extended period of time, we recommend that
you switch off the flash unit with the
button and remove the power source
(disposable/rechargeable batteries).

3.4 The selection menu

• Press the
k
The selection menu is divided into 4 sensor
buttons:
The modes of operation can be set after
pressing the
TTL, see 7.1
TTL FP, see 7.4
M, see 7.3
M FP, see 7.4
SLAVE, see 10.2
SERVO, see 10.4
134
button.
The start screen appears.
The flash unit always switches on
afterwards with the mode of operation that
was used last (e.g. manual flash mode M).
D
button flashes red in stand-by
button until all displays turn off.
D
button as often as it takes
for the selection menu to appear.
MODE
button.
The flash parameters can be set after
PARA
pressing the
button.
EV (exposure correction), see 8
Zoom (reflector setting), see 9.1
F (aperture)
ISO (light sensitivity),
P (partial light output),
see 7.3 and 10.4.3
CHANNEL
3)
(Channel), see 10.1.2, 10.2.2
GROUP
3)
(slave group), see 10.2.3 .
3) only in SLAVE mode
The touch display can be configured after
SERVICE
pressing the
button, or the flash unit
can be reset to the factory setting.
CONTRAST see 14.1
BRIGHTNESS see 14.2
ROTATION (rotate the screen display),
see 14.3
RESET, see 15.3

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido