Product Description - Woods MRD20 Manual De Instrucciones

Operating Instructions
GB

PRODUCT DESCRIPTION

3. Product description
A
1. Handle
2. Control panel
3. Top lid
4. Swing function
5. Front case
B
1. Air plate
2. Continuous drain pipe
3. Power cord
4. Back casing
5. Water tank
C Control Panel
1. Display function
D Picture D (Picture of symbols on control
panel)
1. Power button: This button can control the
machine on/off.
2. Mode button: This button can set the machi-
ne to work under dry mode or dehumidifica-
tion mode.(during dry mode, it dehumidifies
continuously under the highest speed)
3. Humidity button: During dehumidifi-
cation mode, this button can set diffe-
rent desired humidity and the range is
50-55-60-65-70-Co-40-45-50-55-60-65-
70%RH.
4. Timer button: During operation, if you press
this button for <0.5 secunds it can set timer
off function 0H/1H/2H/3H/4H/5H/6H/7H/8H
to operate a countdown.
5. Fan speed button: This button can set machi-
ne to work under low speed or high speed.
6. Swing button: This button can set machine
to swing or not swing automatically.
7. Defrost active
8. Water bucket full
9. Child lock: If press timer button for 3 secunds
it can set child lock function on or off. During
child lock function, only timer and on/off
butons can be set. Just press this button
for 3 seconds again to switch off child lock
function.
10
E
TOP AND BUTTON
1. Sketch on the top and underneath the
machine
F
1. The dehumidifier must have at least 20 cm
free space around the entire dehumidifier.